телефоны: +7(495) 760-70-69 , +7(916) 870-29-57


AOE1065 AOE1090


  WARNING! Do not extract caustic or flammable products. Do not expose the reservoir to any source of heat. While extracting high temperature oils, keep hands and face protected. Only use the device for the purpose for which it has been designed. Do not modify any component of the equipment. Only use original spare parts. Our technical office is at you full disposal for any information you may need ATTENTION! Some cars have a built-in oil suction probe. In this case, connect the coupler of the oil changer B directly to the probe. For other makes of car (Volkswagen-BMW) equipped with a built-in probe having a different opening, connector(C-Volkswagen, D-BMW) must be used.

ASSEMBLY Fig.1: Insert the handle H into its seat and secure it with the screws provided. position the tool tray G. Fig.2: Attach the venture group to the tank. Make sure the gasket is properly positioned. Tighten the ring nut J using a suitable wrench. Fig.3: Connect the drain hose with the ball valve and adapter I on the base of the units tank.

CHARGING THE SYSTEM Fig.4: Open completely the valve K by turning it counter clockwise. Close the suction valve (ball valve) A. Close the air valve (ball valve) L. Close the drain valve (ball valve) B. Fig.5: Connect compressed air 100psi (7bar) to quick couple D, Open the ball valve C and valve F. Air will flow out from the muffler E. When the arrow of the vacuum gauge approaches the red field, after 2.5-3min, close the ball valve C ,then shut-off the compressed air. The unit is now depressurized and ready for use. 

OPERATION Oil should always be removed when they are hot (70-80 ? C). The suction capacity of the unit is equal to 2/3 of its reservoir capacity. With the engine still warm, remove the dipstick and insert the largest possible probe as far down as it will go. Connect the suction hose to the probe. Open ball valve A, keeping the probe dipped in the oil. As soon as the sump is emptied, close ball valve A. It is also possible to suck hot waste oil while keeping the air connected to the device. EMPTYING IMPORTAN! Make sure that valve K and F is closed. Open the valve B. Connect compressed air (7 psi-0,5Bar) to quick couple M, open the ball valve L until all fluids have been transferred from the unit’s storage tank. The unit storage tank has been equipped with a safety valve calibrated at 14 PSI-1BAR.  


    телефоны: +7(495) 760-70-69 , +7(916) 870-29-57